Smart Square Form 120pcs

The Smart Forms by Cactus are an alternative to classic Nail Forms, allowing you to create the skeleton of the nail to be reconstructed right away.

Thanks to the Smart Forms, you can create any shape of the skeleton and then proceed with the classic technique for the apex.

The Cactus Smart Forms are transparent, with guidelines specifically designed to facilitate the application of the product inside, achieving the desired shape immediately.

They have been designed to be very flexible but at the same time resistant, a feature that allows you to save time in choosing the size.

Unlike the Smart Forms, these tips can be used on any type of nail plate, regardless of curvature.

To choose the right Smart for each finger, you need to place the tip on the nail and ensure that it perfectly matches the growth points on the sides of the plate. The Smart must "hug" the nail without applying pressure, covering the entire surface perfectly.

Each size is described in the product images.

SMART FORM APPLICATION

• Remove any old product.
• Matte the entire surface of the nail plate very carefully with the 180 grit file or buffer. Avoid leaving shiny areas as the product would not adhere properly.
• Clean and degrease the nails with Nail Prep Cactus, wait 30 seconds for the product to completely evaporate.
• Apply Bonder Scotch in a thin layer, massaging it over the entire plate. Wait 1 minute for it to dry completely in the air.
• Apply base Step One in a thin layer, massaging the nail while avoiding contact with the skin. Be careful to cover the entire surface of the nail well. Cure.(Fare attenzione perché se non si copre bene la lamina ungueale con la base, si rischia che il gel non aderisca bene)
• Select the right size of the Smart Form for each finger (see description)
• Apply the chosen product (gel or acrygel ) in the Smart, immediately creating the desired shape. In case, especially - but not only - of self-leveling Gel like Mousse or Sorbetto , it is necessary to pay particular attention to the thickness of the sides, so as not to leave them too thin.
• Blend the product in the part that will adhere to the nail, so that towards the end the amount is practically zero.
• Maintaining an inclination of 45°, place the Smart Form at the area of the “stress point” which is located approximately in the middle of the nail bed.
• Once you are sure that the Smart Form is straight, lower and reduce the tilt while maintaining pressure at the stress point, until the sides of the Smart are parallel to the finger (it should not go up or down, as this could create an incorrect shape that could lead to cracks and breaks)
• Use the UV bulb by placing it only near the cuticle area and polymerize for 10 seconds.
• Flip the finger and remove any excess product or level it with the help of a brush.
• Once the structure is leveled, polymerize in the lamp for 1 minute . If desired, pinch the form by placing the clamp over the Smart, after 15 seconds of polymerization.
• Remove the Smart by applying light pressure with your fingers on both sides, starting from the growth points until reaching the tip.
• Shape as desired with the file, use the drill on the underside of the nail to remove excess product and refine any steps, if present, with the Carbide finishing bit “Blue Finishing d0215”.
• Create the arch with the desired product. In the case of long nails (free edge longer than the nail bed), it is recommended to use Sorbetto gel or Mousse Gel, both suitable for the no filing technique. If the nails are shorter, you can use, in addition to the aforementioned gels, the Hard base which ensures durability.
• Apply the color in two thin layers, if desired, and then seal with the Top Coat Reflex no Wipe.