Dual Form Stiletto - 120 pcs

The Cactus Dual Forms are an alternative to classic Nail Forms, allowing you to create the entire structure of the nail to be reconstructed right away.

Thanks to the Dual Forms, you can create any natural shape from the salon, as well as extreme shapes thanks to the wide selection offered by our collection.

The Cactus Dual Forms are transparent, with guidelines specifically designed to facilitate the application of the product inside, achieving the desired shape immediately.

They have been designed to be very flexible yet at the same time durable, a feature that saves time in choosing the size and minimizes the risk of creating steps in the cuticle area.

Every type of nail can find a Dual shape that fits perfectly. It is important to choose the Dual based on the shape of the nail plate we will be working on:

With a single type of Dual Form, it is possible (in most cases) to create different shapes during the reconstruction phase.

You can find examples of achievable shapes in the second slide of the product photos.

To choose the right Dual for each finger, you need to place the tip on the nail and ensure that it perfectly matches the growth points on the sides of the nail plate. The Dual must "embrace" the nail without applying pressure, perfectly covering the entire surface.

Each size is described in the product images.

DUAL FORM APPLICATION

• Remove any old product.
• Carefully buff the entire surface of the nail plate with a 180 grit file or buffer. Avoid leaving shiny areas as the product would not adhere properly.
• Clean and degrease the nails with Nail Prep Cactus, wait 30 seconds for the product to completely evaporate.
• Apply Bonder Scotch in a thin layer, massaging it over the entire nail plate. Wait 1 minute for it to dry completely in the air.
• Apply base Step One in a thin layer, massaging the nail while avoiding contact with the skin. Be careful to cover the entire surface of the nail well. Polymerize. (Be careful because if the nail plate is not well covered with the base, there is a risk that the gel will not adhere properly)
• Choose the right size of the Dual Form for each finger (see description)
• Apply the chosen product ( Gel or Acrygel) in the Dual, immediately creating the desired shape.In case, especially - but not only - of self-leveling Gel such as Mousse or Sorbetto, it is necessary to pay particular attention to the thickness of the sides, so as not to leave them too thin.
• Blend the product in the area of the cuticle so that towards the end the amount is practically zero.
• Maintaining an inclination of 45°, lay the Dual on the area of the cuticle, keeping a distance of 2mm from it.
• Once you are sure that the Dual is straight, lower and reduce the tilt while maintaining pressure at the cuticle area, until the sides of the Dual are parallel to the finger (it should not go up or down, as this could create an incorrect shape that could lead to cracks and breaks)
• Use the UV bulb by placing it only near the cuticle area and polymerize for 10 seconds.
• Flip the finger and remove any excess product or level it with the help of a brush.
• Once the structure is leveled, polymerize in the lamp for 1 minute. If desired, pinch the form by placing the clamp over the Dual, after 15 seconds of polymerization.
• Remove the Dual by applying slight pressure with your fingers on both sides, starting from the growth points until reaching the tip.
• Shape as desired with the file, use the drill on the underside of the nail to remove excess product and refine any steps, if present, with the Carbide finishing bit “Blue Finishing d0215”.
• Apply the color in two thin layers, if desired, and then seal with the Top Coat Reflex no Wipe.