Liquid Gel Warm Peach 14 ml

1. Carefully remove the old product.
2. Carefully dull the entire surfaceof the nail plate using a240 grit fileor100 grit buffer. Avoid leaving shiny areas, as they may compromise product adhesion.
3. Clean and degrease nails withCleanserand wait approximately 30 seconds for it to evaporate completely.
4. If desired, apply primers.
5. Apply a thin, massaged layer of STEP ONE base; then reapply the product like a polishand only then cure. Make sure to uniformly cover the entire nail surface without touching the skin. If the base does not completely cover the nail plate, the gel will not adhere properly.
6. Proceed with the application ofLiquid Gelby first applying the slip layer.
7. Place a drop of product in the apex area and then evenly drag it towards the tip.
8. Subsequently, if necessary, even out the surface with athin brush.
9. Flip the finger, keeping the back parallel to a horizontal surface to allow the product to self-level, and once satisfied, cure.
10. Remove the dispersion layer of the product.
11. If the product application is not precise, you can file the surface. After this step, make sure to remove dust and degrease the nails again.
12. It can be sealed withReflex top coat, leaving its shade for a clean and natural effect, or, if desired, proceed with the application ofcolorand/ornail art, then seal.

Removal:The product can be removed with either anail drillor afile. For removal with a nail drill, it is recommended to use a carbide bit, progressively reducing abrasiveness and RPMs as you approach the nail plate, to ensure safe processing.

Useful information:

• Requires base coat application for adhesion.
• The product, especially in more pigmented colors, should not be applied in thick layers (>1.4mm), otherwise it may not cure.
• It is recommended to use the product indual forms, only with less opaque colors. In the case of downturned nails, do not use highly pigmented colors as there is a risk of thicknesses exceeding 1.4 mm.
• When covering the natural nail, to ensure product hold, a minimum thickness of ~0.7 mm is required at the tip. To achieve this, it is necessary to lightly file the free edge to open up the thickness and achieve the desired height.

ALIPHATIC URETHANE METHACRYLATE, BIS-HEMA POLYNEOPENTYL GLYCOL ADIPATE/IPDI COPOLYMER, TRIMETHYLOLPROPANE TRIMETHACRYLATE, ISOBORNYL METHACRYLATE, HYDROXYPROPYL METHACRYLATE, HYDROXYCYCLOHEXYL PHENYL KETONE, ETHYL TRIMETHYLBENZOYL PHENYLPHOSPHINATE, SILICA DIMETHYL SILYLATE, BIS-HEA POLY(1,4-BUTANEDIOL)-9/IPDI COPOLYMER, CI 77891, POLYPROPYLENE GLYCOL, CI 16035, SILICA, P-HYDROXYANISOLE, CI 15880, HYDROQUINONE, CI 77491, CI 77499