Liquid Gel Nude Caramel 14 ml

1. Carefully remove the old product.
2. Carefully dull the entire surfaceof the nail plate using a240 grit fileor100 grit buffer. Avoid leaving shiny areas, as these could compromise product adhesion.
3. Clean and degrease nails withCleanserand wait approximately 30 seconds for it to evaporate completely.
4. If desired, apply primers.
5. Apply the base STEP ONEin a thin, massaged layer; thenreapply the product like polishand only thencure. Make sure to uniformly cover the entire nail surface without touching the skin. If the base does not completely cover the nail plate, the gel will not adhere properly.
6. Proceed with the application ofLiquid Gelby first applying the slip layer.
7. Place a drop of product in the apex area and then evenly drag it towards the tip.
8. Subsequently, if necessary, even out the surface with athin brush.
9. Flip the finger, keeping the back parallel to a horizontal plane to allow the product to self-level, and once satisfied, cure.
10. Remove the dispersion layer of the product.
11. If the product application is not precise, you can file the surface. After this step, make sure to remove dust and degrease the nails again.
12. It can be sealed withReflex top coatleaving its shade for a clean and natural effect, or, if desired, proceed with the application ofcolorand/ornail art, and then seal.

Removal:The product can be removed with both adrilland afile. For drill removal, it is recommended to use a carbide bit, progressively reducing abrasiveness and RPM as you get closer to the nail plate, to ensure safe work.

Useful information:

• Requires base application for adhesion.
• The product, especially in more pigmented colors, should not be applied in thick layers (>1.4mm), otherwise it may not cure.
• It is recommended to use the product indual formsonly with less opaque colors. In the case of downward-sloping nails, do not use highly pigmented colors as there is a risk of thicknesses exceeding 1.4 mm.
• When covering the natural nail, to ensure product hold, the tip must have a minimum thickness of ~0.7 mm. To achieve this, it is necessary to lightly file the free edge, to open up the thickness and achieve the desired height.

ALIPHATIC URETHANE METHACRYLATE, BIS-HEMA POLYNEOPENTYL GLYCOL ADIPATE/IPDI COPOLYMER, TRIMETHYLOLPROPANE TRIMETHACRYLATE, ISOBORNYL METHACRYLATE, HYDROXYPROPYL METHACRYLATE, HYDROXYCYCLOHEXYL PHENYL KETONE, ETHYL TRIMETHYLBENZOYL PHENYLPHOSPHINATE, SILICA DIMETHYL SILYLATE, BIS-HEA POLY(1,4-BUTANEDIOL)-9/IPDI COPOLYMER, CI 77891, POLYPROPYLENE GLYCOL, CI 16035, SILICA, P-HYDROXYANISOLE, HYDROQUINONE, CI 15880, CI 77499