{"product_id":"gel-tips-mandorla-600-pcs","title":"Gel Tips Almond - 600 pcs","description":"\u003cp\u003eThe Gel Tips should be applied exclusively on the nail plate, with a maximum free edge of 2 mm to facilitate attachment.\u003c\/p\u003e\n\u003cul\u003e\n\u003cli\u003eAfter removing any residual product, shorten the free edge. Matt the plate with a 180 grit file and then the cuticle area with the drill (using a red flame bit of any diameter) but without going too deep as the manicure will be performed later. Ensure that the entire nail surface is matted.\u003c\/li\u003e\n\u003cli\u003eDust and degrease with the cleanser twice, ensuring that the plate is completely clean and dehydrated.\u003c\/li\u003e\n\u003cli\u003eIf you wish to apply the primers, you must follow these steps: apply the \u003ca href=\"https:\/\/cactusforyou.com\/products\/nail-prep-cactus-10ml\" title=\"Nail Prep Cactus\" rel=\"noopener\" target=\"_blank\"\u003eNail Prep Cactus\u003c\/a\u003e, allowing it to air dry for 30 seconds.Once the drying is complete, apply a tiny drop of \u003ca href=\"https:\/\/cactusforyou.com\/products\/primer-senza-acido-scotch-vitamins\" title=\"Primer senza Acido Scotch with vitamins\" rel=\"noopener\" target=\"_blank\"\u003eAcid-Free Scotch Primer\u003c\/a\u003e on the nail plate and massage the product with a gel brush over the entire nail plate, avoiding contact with the skin. Wait 1 minute for air drying. If you do not intend to apply the preparers, proceed directly to the next step.\u003c\/li\u003e\n\u003cli\u003eApply the Base Step One in two phases: first, spread a small amount of product by massaging it with a brush. Immediately after, apply a coat like nail polish. Once these steps are completed, cure for 1 minute in a UV\/LED lamp.\u003c\/li\u003e\n\u003cli\u003eSelect the Gel Tips that best fit the nail plate, placing the tip on the natural nail. \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003e\u003cem\u003e\u003cstrong\u003eAttention, do not choose the tip as if it were a dual form: dual forms, unlike Gel Tips, need space in the side areas to ensure the correct thickness of the gel once removed.The Gel Tips, on the other hand, will not be removed, so they must be chosen based on the size and shape of the nail plate. If there is a lot of free space in the lateral area, between the tip and the nail, at the time of attachment the tip will drop too much due to pressure and will go beyond the nail plate, resulting in being too large.\u003c\/strong\u003e\u003c\/em\u003e\u003c\/p\u003e\n\u003cul\u003e\n\u003cli\u003eOnce the tip is chosen, it must be prepared:\n\u003cul\u003e\n\u003cli\u003eThin out the cuticle edge to avoid the formation of a large visible step that would then need to be filed with the drill.\u003c\/li\u003e\n\u003cli\u003eMatte the inside of the tip with a buffer of any grit or with a diamond drill bit.\u003c\/li\u003e\n\u003cli\u003eDegrease the inside with the cleanser. After this step, the tip may turn white.\u003c\/li\u003e\u003c\/ul\u003e\n\u003c\/li\u003e\n\u003cli\u003eIf you are using the Hard Cactus Base to attach the tip, it is important to first apply the Step One Base inside in a thin layer and cure it in a UV\/LED lamp for 1 minute. This step is essential because the Hard Cactus Base is a rigid base, not an adhesion base. The Step One Base, on the other hand, is an adhesion base that allows the tip to adhere perfectly to the Hard Base.\u003c\/li\u003e\n\u003cli\u003eApply the Hard Base in a thin sliding layer and then apply a drop. Position the gel tip at a 45-degree angle and lower it until it becomes parallel with the finger, ensuring that it is straight and has covered the sides. Hold it for 15-20 seconds with a mini lamp.\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003e\u003cem\u003e\u003cstrong\u003eIf you are not using the Hard Cactus Base, you can use either the Step One Base or the Universal Base in both steps, both of which are adhesion bases that allow for perfect adherence of the tip.\u003c\/strong\u003e\u003c\/em\u003e\u003c\/p\u003e\n\u003cul\u003e\n\u003cli\u003eComplete the polymerization in a UV\/LED lamp for 1 minute.                    \u003c\/li\u003e\n\u003cli\u003eRefine the edge of the tip in the cuticle area, even if it is not very noticeable, using a finishing bit and\/or a flame bit.\u003c\/li\u003e\n\u003cli\u003eApply a layer of Base Step One near the cuticle area to encapsulate the tip with the natural nail, making sure to apply the product beyond the edge of the tip. Polymerize. This step helps to prevent lifting at the cuticle area.\u003c\/li\u003e\n\u003cli\u003eContinue with a complete manicure, applying color and Top Coat.\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003eWith this technique, you will achieve a structure that is already ready and very durable. It will not be necessary to shape any curvature on the surface of the tip with additional gel.\u003c\/p\u003e","brand":"CACTUS FOR YOU SRL","offers":[{"title":"Default Title","offer_id":54966160097663,"sku":"CGT-YS-433","price":21.0,"currency_code":"EUR","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0852\/1148\/0367\/files\/gel-tips-mandorla-600-pcs-cactus-for-you-314272.jpg?v=1745405859","url":"https:\/\/cactusforyou.com\/en-eu\/products\/gel-tips-mandorla-600-pcs","provider":"CACTUS FOR YOU","version":"1.0","type":"link"}